User Manual Q&AAnswer
Feb 28, 2025 - 10:53 AM
To connect your speakers to the PYLE PT250BA Home Theater Wireless BT Streaming Receiver Amplifier, follow these steps:
1. Identify the speaker output terminals on the rear panel of the amplifier. There are two sets of speaker output terminals labeled A and B.
2. Determine the impedance and wattage of your speakers. It is important to use speakers with the same wattage and impedance when connecting multiple pairs of speakers.
3. Strip off the vinyl coating from the speaker wires and twist the wire tips.
4. For each speaker, push down the pink jack or loosen the xxxx terminal on the appropriate speaker output terminal.
5. Insert the wire tips into the terminal and then fasten it and tighten the xxxx . Make sure the wires are securely connected and not sticking out of the terminal.
6. Repeat the above steps for each speaker you want to connect.
7. Once all the speakers are connected, turn on the amplifier and adjust the main volume to the desired level.
Note: It is recommended to consult the user manual for further details and safety instructions before connecting the speakers.
Add New Comment