User Manual Q&AAnswer
Feb 28, 2025 - 09:18 AM
To connect the Surenoo STP0114A-135240 Series TFT LCD Panel to your device, you will need to use the FPC connector on the module. The pin definitions for the FPC connector are as follows:
1. NC (No Connect)
2. NC (No Connect)
3. SDA (SPI interface input/output pin)
4. SCL (Serial interface clock)
5. RS (Display data/command selection pin in 4-line serial interface)
6. RESET (Signal to reset the device, active low)
7. CS (Chip selection pin, low enable, high disable)
8. GND (Power ground)
9. NC (No Connect)
10. VDD (Power supply for analog)
11. LEDK (LED Cathode)
12. LEDA (LED Anode)
13. GND (Power ground)
Please refer to the manual for more detailed information on the pin definitions and how to connect the module to your device.
Add New Comment