Answer

Feb 28, 2025 - 08:47 AM
To reverse the door swing on your SUMMIT SPR623OS Built-In Refrigerator, please follow these steps:
1. Carefully lay the appliance on its back, using cushioning to protect the floor and the unit.
2. Using a Phillips screwdriver, remove the two screws on the bottom right hinge at the bottom of the door. Keep the hinge in a safe place in case you need to reverse the door again in the future.
3. Carefully slide the door off and place it on a padded surface.
4. Interchange the plastic shaft sleeves at the top of the door.
5. Remove the bottom support bracket from the right side.
6. Remove the top right hinge.
7. Remove the screws from the top left and transfer them to the right.
8. Install the top left hinge.
9. Install the bottom left hinge to the door. DO NOT OVERTIGHTEN THE xxxx .
10. Place the door back on the appliance, lining up the top hinge.
11. Install the bottom support bracket.
12. Adjust door alignment. When set, tighten the screws on the hinge.
13. Remove the handle. Transfer the xxxx hole covers to the left, then install the handle on the right.
Note: Keep the other hinge in a safe place in case you want to reverse the door in the future.
For visual reference, please consult the "Reversing the Door Swing" section in the owner's manual of your SUMMIT SPR623OS Built-In Refrigerator.
Add New Comment