User Manual Q&AAnswer
Feb 28, 2025 - 08:38 AM
To connect the Surenoo STP0144C-128128 Series TFT LCD Panel to your device, you will need to follow the pin connections as specified in the manual. Here is the pin connection information:
1. LEDK: back light power supply negative
2. GND: Ground
3. FMARK: Tearing effect output pin to synchronize MCU to frame rate
4. SDA: the serial input/output signal in serial interface mode.
5. RS: Display data/command selection pin in 4-line serial interface
6. SCK: used to be serial interface clock.
7. CS: chip select signal input
8. RESET: A reset pin.
9. IOVCC18: Power Supply for I/O system. (1.8V or VCC)
10. VCC28: Power Supply for Analog, Digital System and Booster Circuit.
11. GND: Ground
12. LEDA: back light power supply positive
13~15. NC: No Connect
Please make sure to connect the pins correctly according to your device's requirements.
Add New Comment