User Manual Q&AAnswer
Feb 28, 2025 - 07:09 AM
To connect the Surenoo STP0144A-128128 Series TFT LCD Panel to a micro-controller, you will need to use the SPI interface. The pin descriptions in the user manual provide the following information:
- Pin 8 (SDA) is the serial data input/output pin.
- Pin 9 (SCK) is the serial clock pin.
- Pin 11 (IOVCC) is the power supply for the interface (1.8V-3.3V).
- Pin 12 (CS) is the chip select pin. When it is set to "Low", it enables the LCD module.
You will need to connect these pins to the corresponding pins on your micro-controller. Additionally, make sure to connect the ground pins (pins 2 and 5) and the power supply pins (pins 10 and 11) appropriately.
Please refer to the user manual for any further details or specific instructions on connecting the LCD panel to your micro-controller.
Add New Comment