User Manual Q&AAnswer
Feb 28, 2025 - 05:15 AM
To determine the appropriate location for installing the ITC 85606-SS 7 Inch Stainless Steel Assist Handle, you need to ensure that there is structural support behind the handle. Failure to install the handle into adequate support can void the warranty and may result in the handle pulling out of the wall.
To find the appropriate location, you can follow these steps:
1. Identify the area where you need the assist handle. Consider the purpose of the handle and the specific needs of the user.
2. Check the wall or surface where you plan to install the handle. Look for any signs of structural support, such as studs or beams, behind the wall. You can use a stud finder tool to locate the studs.
3. Once you have identified the potential installation location, mark the xxxx holes on the wall using a pencil or marker. Make sure the marks align with the holes on the assist handle.
4. Before drilling, ensure that the marked locations correspond to the presence of structural support behind the wall. You can tap on the wall to listen for a solid sound, indicating the presence of a stud.
5. Once you are confident about the location, use a power drill to create pilot holes at the marked positions. The pilot holes will make it easier to insert the screws during installation.
6. Place the assist handle over the pilot holes, aligning the holes on the handle with the holes on the wall.
7. Finally, secure the handle in place by using 5/16-18 stainless steel screws. Please note that the screws are not provided with the handle, so you will need to purchase them separately.
By following these steps and ensuring proper structural support, you can install the ITC 85606-SS 7 Inch Stainless Steel Assist Handle securely and safely. For any warranty-related information, please refer to the manufacturer's website or contact their customer support.
Add New Comment