User Manual Q&AAnswer
Feb 28, 2025 - 05:10 AM
To install the ITC 693RS-FF-KK-UML Rectangular Push Lens Courtesy Light, please follow these steps:
1. Disconnect power: Before starting the installation, make sure to disconnect the power source to avoid any electrical hazards.
2. Mark and drill pilot holes: Use the provided cutting template to mark the corners and xxxx holes on the surface where you want to install the light. Then, drill pilot holes at the marked positions.
3. Wire the light: Follow the wiring diagram provided in the instruction manual to properly connect the wires of the courtesy light. It is recommended to add fuse protection to the positive (+) input for safety.
4. Attach the light: Using the provided screws, attach the courtesy light to the surface by aligning the xxxx holes with the pilot holes. Apply silicone sealant around the wires and xxxx holes to prevent water ingress and ensure a watertight seal.
5. Snap on decorative bezel: Once the light is securely attached, snap on the decorative bezel to give it a finished look.
Please note that this answer is based on the information provided in the ITC 693RS-FF-KK-UML Rectangular Push Lens Courtesy Light instruction manual. For further assistance or warranty information, you can visit the manufacturer's website at www.itc-us.com/warranty-return-policy or contact their customer support at the provided phone number.
Add New Comment