How do I install the EMTEK Dummy Mortise Lock Lever by Lever, xxxx by xxxx ? (EMTEK Dummy Mortise Lock Installation Guide)

Answer

manuals.plus

Feb 28, 2025 - 04:56 AM


To install the EMTEK Dummy Mortise Lock Lever by Lever,  xxxx  by  xxxx , please follow the steps below:

1. Start by preparing the door according to the specifications provided in the template. The template should outline the necessary measurements and hole placements for the lockset.

2. Once the door is prepped, you can begin installing the plates and knobs/levers. It's important to note that the plates and knobs/levers may vary depending on the chosen style.

3. Begin by placing the backplate on the interior side of the door. Align the holes on the backplate with the pre-drilled holes on the door. Secure the backplate in place using the provided screws.

4. Next, attach the lever or  xxxx  to the backplate. Insert the spindle through the hole in the backplate and align it with the square hole in the lever or  xxxx . Make sure the lever or  xxxx  is facing the correct direction and tighten the set  xxxx  on the side to secure it in place.

5. Repeat the same process for the exterior side of the door, ensuring that the backplate, lever, or  xxxx  are aligned properly.

6. Once both sides are installed, test the functionality of the dummy lock by turning the lever or  xxxx  to ensure it operates smoothly.

Please note that this is a general installation guide, and it's always recommended to refer to the specific instructions provided with the EMTEK Dummy Mortise Lock Lever by Lever,  xxxx  by  xxxx  for accurate and detailed installation steps.