Answer

Feb 28, 2025 - 04:55 AM
To install the EMTEK Wilshire Passage Privacy xxxx or Lever, please follow the steps outlined in the installation guide provided:
1. Door Prep: Ensure that the door jamb is prepared according to the dimensions provided in the guide. Use the strike plate outline edges to locate the xxxx holes on the strike plate and align them with the center line on the jamb.
2. Install Strike Plate: Fasten the strike plate to the door jamb using the provided #8 wood screws.
3. Install Latch: Install the latch mechanism on the edge of the door, ensuring it aligns properly with the strike plate.
4. Install Outside and Inside Trims: Position the outside trim through the bore hole on the exterior side of the door. Make sure the release holes on the trim line up with the privacy pin. Fasten the inside trim using the provided #8 machine screws. Install the privacy pin.
5. Dummy Installation: If installing a dummy xxxx or lever, align the mounting plate with the bore hole and secure it in place.
6. Adjust for Level: Ensure that all components are properly aligned and adjust the mounting plate for levelness.
7. Assemble Lever/ xxxx & Rosette: Attach the lever/ xxxx and rosette to the mounting plate, following the instructions provided in the guide.
Please note that these are general instructions, and it is important to refer to the specific installation guide provided with your EMTEK Wilshire Passage Privacy xxxx or Lever for detailed and accurate instructions. Also, be aware of the warning regarding the exposure to chemicals mentioned in the guide and take necessary precautions.
Source: https://manuals.plus/emtek/wilshire-p... xxxx -or-lever-manual
Add New Comment