Answer

Feb 28, 2025 - 04:23 AM
To install the water filter in the Fisher & Paykel RF135BLPJX6 N FP US refrigerator, follow these steps:
1. Locate the water filter bracket inside the refrigerator compartment.
2. Remove the bracket cover by pressing the tabs on the sides and pulling it out.
3. Take the new water filter and remove the protective cap from both ends.
4. Insert the water filter into the bracket, aligning the arrows on the filter with the arrows on the bracket.
5. Push the filter firmly until it locks into place.
6. Replace the bracket cover by sliding it back into position until it clicks.
7. Run water through the dispenser for approximately 3 minutes to flush out any air or impurities in the new filter.
8. Reset the water filter indicator on the control panel by pressing and holding the "Filter Reset" button for 3 seconds.
For more detailed instructions and illustrations, please refer to the "Water Filter Installation" section of the owner's manual for the Fisher & Paykel RF135BLPJX6 N FP US refrigerator.
Add New Comment