User Manual Q&AAnswer
Feb 28, 2025 - 03:59 AM
To install the ITC 69231B and 69240 LED Radiance Light, you will need the following parts/tools: Radiance Overhead Light, wire nuts (not provided), power drill with a hole saw bit (not provided), and mounting screws (not provided). Here are the steps to follow:
1. Disconnect power: Before starting the installation, make sure to disconnect the power source to avoid any electrical hazards.
2. Account for all parts: Ensure that you have received all the necessary parts and accessories for the light fixture. Also, remember to dispose of all packaging materials properly, especially to prevent any hazards to children.
3. Fuse protection: It is recommended to add fuse protection to the positive (+) input of the light fixture for additional safety.
4. Determine installation location: Decide where you want to install the LED light fixture. Once determined, use a power drill with a hole saw bit to drill a hole according to the specified size requirement. The size of the hole will depend on the model: 2.25" for 69231B and 3.5" for 69240.
5. Wiring: Refer to the wiring diagram provided in the manual to correctly wire the light fixture to the power source of your unit. Follow the instructions carefully to ensure proper electrical connections.
6. Installation methods:
- Spring clip version: Push the clips on both sides of the light fixture up and slide the housing and clips through the drilled hole. The clips will snap down and hold the light in place.
- xxxx mount version: Twist the cover of the light fixture counter clockwise to remove it. Mark the location of the xxxx holes and pre-drill them. xxxx in the fixture and re-install the cover by twisting it clockwise.
- Leaf spring version: Push the light fixture in at an angle and press down on the opposite side until the light is firmly seated in the drilled hole.
By following these instructions, you should be able to successfully install the ITC 69231B and 69240 LED Radiance Light.
Add New Comment