User Manual Q&AAnswer
Feb 28, 2025 - 03:46 AM
Sure! Here is a step-by-step guide on how to install the :
1. Preparation:
- STEP 1: Start by removing the inside lever or xxxx . Use the hex wrench provided to loosen the set xxxx and remove the lever or xxxx .
- STEP 2: Unthread the rosette counterclockwise to remove it from the housing before installing it on the door.
2. Install Chassis:
- Place the inner housing onto the surface of the door. Make sure to orient the notch on the housing to the bottom. The two wood screws should be located at the top and bottom of the housing.
3. Thread Rosette into Housing:
- Take the rosette and thread it into the housing. Rotate it clockwise until it is securely in place.
4. Secure Rosette with Locking Ring:
- Once the rosette is threaded into the housing, locate the locking ring. Slide the locking ring over the rosette and tighten it by turning it clockwise. This will secure the rosette in place.
5. Install Lever or xxxx :
- Finally, install the lever or xxxx into the housing. Make sure it is aligned properly and insert it into the housing until it is fully seated.
By following these steps, you should be able to successfully install the EMTEK Key in Lever/ xxxx Dummy. If you have any further questions or need additional assistance, please refer to the installation guide provided with the product.
Source: https://manuals.plus/emtek/key-in-lever- xxxx -dummy-manual
Add New Comment