User Manual Q&AAnswer
Feb 28, 2025 - 03:44 AM
To set the dimming range for the Merten MEG5300-0001 Universal LED Dimmer Module, follow these steps:
1. Make sure that the circuit breaker is switched on and the connected load is turned off using the programming push-button.
2. Set the function potentiometer to either MIN or MAX, depending on whether you want to set the minimum or maximum brightness.
3. Press the programming push-button shortly three times. The dimmer module will enter programming mode, and the status LED will flash according to the operating mode.
4. Depending on your selection in step 2, hold down the programming push-button to set the minimum or maximum lamp brightness.
5. The new value will be automatically saved after 8 seconds if the programming push-button is not pressed again during this time. The connected load will be automatically switched off, and the status LED will light up for 2 seconds.
It is important to note that the dimming range should be set according to the technical data provided and the specific requirements of your connected load.
Add New Comment