Answer

Feb 28, 2025 - 03:41 AM
To properly install the EMTEK Single Cylinder Deadbolt Lock on a regular door, please follow these steps:
1. Door Prep:
- Measure and mark the desired height for the deadbolt on the door edge.
- Use a hole saw to drill a 2-1/8" diameter hole through the door at the marked height.
- Drill a 1" diameter hole from the edge of the door to intersect the 2-1/8" hole, creating the latch hole.
2. Door Jamb Prep:
- Measure and mark the desired height for the strike plate on the door jamb.
- Use a chisel to mortise the strike plate into the door jamb at the marked height.
3. Install Latch:
- Insert the latch into the 2-1/8" hole on the door edge, ensuring the beveled side faces the direction the door closes.
- Secure the latch with the provided screws.
4. Outside Installation:
- Insert the exterior assembly into the latch from the outside of the door.
- Align the xxxx holes on the exterior assembly with the holes on the latch.
- Secure the exterior assembly to the latch using the provided screws.
5. Inside Installation:
- Insert the interior assembly into the latch from the inside of the door.
- Align the xxxx holes on the interior assembly with the holes on the latch.
- Secure the interior assembly to the latch using the provided screws.
Please refer to the EMTEK Single Cylinder Deadbolts Lock Installation Guide for detailed illustrations and additional information on the installation process.
Add New Comment