User Manual Q&AAnswer
Feb 28, 2025 - 02:58 AM
To cut a hole in the mounting surface for the ITC 69722 and 69723 High Output Docking Light, you will need a 0.875" hole saw. Here are the steps to follow:
1. Mark the desired location on the mounting surface where you want to install the docking light.
2. Attach the 0.875" hole saw to a drill.
3. Position the hole saw over the marked location and start drilling slowly and steadily.
4. Apply gentle pressure and continue drilling until the hole is completely cut through the mounting surface.
5. Once the hole is cut, remove any debris or rough edges around the hole.
Please ensure that you take necessary safety precautions while using power tools and wear appropriate protective gear. Always disconnect power before installing, adding, or changing any component to avoid any potential hazards.
Add New Comment