Answer

Feb 28, 2025 - 02:30 AM
To connect your speaker cabinets to the EBS Reidmar 752 Bass Head, follow these steps:
1. Carefully unpack the bass head.
2. Make sure all knobs are set fully counterclockwise, except for the EQ controls (BASS, MIDDLE, and TREBLE) which should be set to the mid position.
3. Connect one or more speaker cabinets to the speaker output on the rear panel of the amp.
4. Make sure the total impedance of the speaker cabinets is not below 2 ohms.
5. Turn on the POWER switch.
6. Plug in your bass and gradually increase the GAIN xxxx while plucking the strings as hard as you would during your hardest playing. Adjust the GAIN xxxx until the peak LED starts to flash at peaks.
7. Move over to the VOLUME xxxx and adjust it for the desired output volume.
Note: It is important to choose speaker cabinets that can handle the output of the amp. For example, if you are using a 4-ohm cabinet, it should be able to handle at least 450W RMS to match the Reidmar 752.
Please refer to the EBS Reidmar 752 Bass Guitar Amplifier Head User Manual for more detailed information and instructions on using the amp.
Add New Comment