User Manual Q&AAnswer
Feb 28, 2025 - 02:16 AM
To properly align and secure the DAKTRONICS DVN-3001 Series panels during installation, follow these steps:
1. Panel Interconnect Engagement:
- Push the knurled captivated bolts through the cabinet to attach the adjacent cabinets.
- Hand-tighten the knurled captivated bolts loosely until the cabinets are mated but still able to move for adjusting.
- Check the top-to-bottom panel alignment to ensure the panels are level. Adjust the jacking hardware until the panels are flush.
- Finish hand-tightening the captivated bolts as much as possible and then use a Phillips or standard screwdriver to do a final 1/2 to 3/4 turn.
- Feel the top, bottom, and center of the seam to ensure the seam between the panels feels smooth, ensuring proper panel alignment.
2. Self-Drilling xxxx Installation:
- Use the contract-specific Shop Drawing to determine self-drilling xxxx quantities and locations per panel.
- If standard 1/4"-14 screws are being used, use a pilot hole size of 13/64" [5.16 mm]. If alternative screws are being used, find the correct pilot hole size per the hardware specified on the contract-specific Shop Drawing.
- Mark the locations of the self-drilling screws and drill pilot holes at those locations if pilot holes do not already exist.
- Note: For 1x4 tubes, pilot holes must be drilled through both the front and rear walls of the tube to prevent xxxx strip-out.
- Start the attachment of the self-drilling screws in the pilot holes, but do not tighten the screws down.
Please refer to the DAKTRONICS DVN-3001 Series Panel Installation Guide for more detailed instructions and illustrations.
Add New Comment