How do I install the ITC 69810 Beam Courtesy Light? (ITC 69810 Beam Courtesy Light Instruction Manual)

Answer

manuals.plus

Feb 28, 2025 - 01:49 AM

To install the ITC 69810 Beam Courtesy Light, follow these steps:

1. Disconnect power: Before installing, adding, or changing any component, make sure to disconnect the power source.

2. Account for all parts: To avoid any hazards to children, ensure that you have received all the necessary parts and destroy all packing materials.

3. Maintain distance from combustible materials: Do not install the luminaire assembly closer than 6 inches from any combustible materials.

4. Fuse protection: It is recommended to add fuse protection to the positive (+) input for safety.

5. Determine installation location: Decide on the installation location and drill a hole using the provided hole saw bit.

6. Remove set xxxx and nut: Take out the set xxxx and nut from the back of the light.

7. Pull wire through the hole: Pull the unit's wire through the hole, ensuring that the nut is placed on the inside before completing the wiring.

8. Wire the light: Refer to the wiring diagram provided below and wire the light to the unit's power. Test the light to ensure it is functioning properly.

9. Feed wires back through the hole: Once the wiring is complete, feed the wires back through the hole.

10. Tighten the nut: Tighten the nut on the back of the light. If possible, also tighten the set xxxx for added support (though not required for installation).

For any further information or warranty details, please visit the ITC website at www.itc-us.com/warranty-return-policy or contact their customer support at 616.396.1355.