User Manual Q&AAnswer
Feb 28, 2025 - 01:20 AM
To connect the Surenoo STP0177A-128160 Series TFT LCD Panel to your device, you will need to follow these steps:
1. Make sure your device has a SPI-4wire interface, as this is the input data method supported by the LCD panel.
2. Connect the LCD panel to your device using the following pins:
- Pin 2 (GND) should be connected to the ground of your device.
- Pin 3 (LED-) should be connected to the cathode of the backlight.
- Pin 4 (LED+) should be connected to the anode of the backlight.
- Pin 5 (GND) should be connected to the ground of your device.
- Pin 6 (/RESET) is the LCM reset pin and should be connected to your device. The signal is active low.
- Pin 7 (A0) is the register select pin and should be connected to your device.
- Pin 8 (SDA) is the serial data input/output pin and should be connected to your device.
- Pin 9 (SCK) is the serial clock pin and should be connected to your device.
- Pin 10 (VCC) is the power supply for the LCD panel and should be connected to a 2.8-3.3V power source.
- Pin 11 (IOVCC) is the power supply for the LCD panel and should be connected to a 1.8-3.3V power source.
- Pin 12 (CS) is the chip select pin and should be connected to your device. The pin should be set to "Low" to enable the LCD panel.
- Pin 13 (GND) should be connected to the ground of your device.
- Pin 14 (NC) is not connected.
Please refer to the Surenoo STP0177A-128160 Series TFT LCD Panel User Manual for more detailed information and specifications.
Add New Comment