User Manual Q&AAnswer
Feb 28, 2025 - 12:26 AM
To assemble the Rcom Auto Pumping System (APS), please follow the steps below:
1. Cut the silicone tube into two lengths: 1m and 0.5m.
2. Attach the cut parts of the silicone tube onto the nipples on either side of the APS unit.
- Make sure there are no blockages in the silicone tube by gently pulling both ends before assembly.
- Ensure that the silicone tube is fitted tightly onto the xxxx and the tube length matches the provided picture in the manual.
3. Insert the xxxx attached to the 0.5m silicone tube into the 'OUT' part (left-hand side) of the xxxx holder, as shown in [Picture B].
4. Insert the xxxx attached to the 1m silicone tube into the 'IN' part (right-hand side) of the xxxx holder, as shown in [Picture C].
5. Assemble the cap onto the pump body, ensuring that the silicone tubes do not get jammed in the cap.
6. Connect the APS power cable onto the power inlet at the back of the pump body.
7. Refer to page 16 of the booklet manual for instructions on how to assemble the APS with the incubator.
Please note that proper assembly is crucial for optimal pumping performance. Make sure to follow the instructions carefully and refer to the provided pictures in the manual for guidance.
Add New Comment