User Manual Q&AAnswer
Feb 27, 2025 - 11:36 PM
To install and connect the PREMIER 1 SolarStop 80 Electric Fence Energizer, follow these steps:
1. Open the side panel (battery compartment) of the energizer and connect the battery. Attach the black wire (negative) to the black terminal and the red wire (positive) to the red terminal. Replace the panel.
2. Insert the mounting stake (sold separately) into the ground using a dead blow hammer or by hand, ensuring it goes the full length of the T ground rod.
3. Attach the wiring harness to the energizer and to the fence:
a. Turn off the energizer.
b. Remove the black terminal xxxx on the energizer.
c. Place the ring connector of the wire with the black clip over the ground terminal stud.
d. Replace the xxxx and tighten it to secure the connection.
e. Attach the black clip to the ground rod.
f. Remove the red terminal xxxx on the energizer.
g. Place the ring connector of the wire with the orange clip over the fence terminal stud.
h. Replace the xxxx and tighten it to secure the connection.
i. Attach the orange clip to the stainless steel connector at the end post of the netting or to the end of a stranded fence.
4. Position the energizer so that the solar panel faces south in full sun.
5. Turn on the energizer and check the voltage at the end of the fence with a fence tester to ensure the fence is properly electrified before introducing it to animals. The minimum voltage at the end of the fence should be 3000V.
Note: It is important to make sure the battery is fully charged before use. You can use the included 110V Recharger or a solar panel to charge the battery. The energizer should be stored indoors when not in use, and debris should be regularly removed from the solar panel to maintain its efficiency.
For more detailed instructions and information, refer to the PREMIER 1 SolarStop 80 Electric Fence Energizer Instruction Manual.
Add New Comment