Answer

Feb 27, 2025 - 08:31 PM
To install the SWISSINNO 12V-DC Marten Stop Car Kit, follow these steps:
1. Prepare the vehicle by thoroughly cleaning the engine compartment and the ground to eliminate any traces of urine scent left by martens.
2. Test the equipment before installation by connecting the red cable to the positive terminal and the black cable to the negative terminal of the car battery. If the green light in the push-button on the control box flashes every 5 seconds, the equipment is working correctly.
3. Assemble the high-voltage sequence by attaching the stainless steel plates to the black plastic mounting blocks using screws. Thread the white high-voltage cable through each block to form a chain of 8 plates.
4. Install the control box by removing the in-line fuse from the red cable and strapping the control box to a solidly fixed component in the engine compartment. Connect the black cable to the negative terminal and the red cable to the positive terminal of the battery.
5. Lay out the white high-voltage cable in the engine compartment, making sure it does not touch hot engine parts or moving engine parts. Use cable ties to secure the mounting blocks with plates onto vulnerable components.
6. Secure the metal plates to the blocks by fully driving in the screws. Ensure that the plates are insulated and not touching anything in the engine compartment.
7. Switch the system on by putting the in-line fuse back into the fuse holder and pressing the push-button ON/OFF switch on the control box. A green light will flash every 5 seconds, indicating that the system is working.
Please refer to the user manual for detailed diagrams and instructions on installation.
Add New Comment