User Manual Q&AAnswer
Feb 27, 2025 - 08:23 PM
To change the frequency band on the MIPRO MTM-24 Wireless Interlinking Transmitter Module, follow these steps:
1. Press and hold the Power Button (C) until the device powers on and the LCD Screen lights up.
2. Press the MODE button to enter the frequency band selection mode. The numeric channel will start blinking on the LCD Screen.
3. Use the UP/DOWN buttons to change the numeric channel to the desired frequency band.
4. Press the MODE button again to enter the ID code selection mode. The numeric ID code will start blinking on the LCD Screen.
5. Use the UP/DOWN buttons to change the numeric ID code to the desired value.
6. Once you have made the desired changes, the blinking on the LCD Screen will stop, indicating that the changes have been saved.
Note: It is important to ensure that the interlinking transmitter module and receiver module have the same frequency band code. If interference occurs, you may need to change the frequency or replace the module with a different frequency band code.
Add New Comment