User Manual Q&AAnswer
Feb 27, 2025 - 07:17 AM
To install the Holley 302-65 Gen.3 Hemi Transmission Lower Structural Support, follow these steps:
1. Position the structural dust cover in the vehicle.
2. Install all four bolts retaining the structural dust cover to the engine hand tight.
3. Install the two cover-to-transmission bolts hand-tight.
4. Tighten the structural dust cover-to-transmission bolts to 80 in./lbs.
5. Tighten the structural dust cover-to-engine block bolts to 80 in./lbs.
6. Retighten the structural dust cover-to-transmission bolts to 40 ft./lbs.
7. Retighten the structural dust cover-to-engine block bolts to 40 ft./lbs.
8. Lower the transmission onto the cross member and remove the jack.
Make sure to hold the structural dust cover tightly against both the engine and the transmission bell housing during the tightening sequence to avoid any damage to the cover.
If you need further assistance or have any other questions, you can contact Holley's technical support at 1-866-464-6553 or 1-270-781-9741. You can also visit their website at www.holley.com for online help.
Add New Comment