User Manual Q&AAnswer
Feb 27, 2025 - 07:09 AM
To mount the SmartPower SYSTEMS Smart 30 3 Phase Surge Protector to a wall or other surface, follow these steps:
1. Install four screws (not included) on the wall where the monitoring lights can be observed. Leave 1/4 inch of the xxxx exposed.
2. Use the two mounting holes in the back of the Smart 30 unit by sliding them into the exposed part of the screws and lock into place.
3. Once securely mounted, you can proceed with the installation of the Smart 30 surge protector.
Please note that the screws for mounting are not included with the surge protector, so you will need to provide your own.
Add New Comment