Answer

Feb 27, 2025 - 06:39 AM
Sure! Here are the step-by-step instructions for replacing the charger port on your Razor Rambler 16:
1. Make sure the power switch is turned OFF and disconnect the charger before starting any assembly or maintenance procedures. This is important to avoid potential shock or injury.
2. Using a Phillips screwdriver, remove the seven (7) screws from the side of the battery cover where the power switch is located.
3. Next, remove four (4) screws - two (2) at the front and two (2) at the back of the battery cover. Carefully pull the cover out, being cautious not to damage any wires.
4. Locate the charger port and disconnect it from the controller. This will allow you to remove the old charger port and replace it with a new one.
5. Using a small Phillips screwdriver, remove the two (2) screws that hold the charger port onto the battery cover. Gently pull the charger port out from the battery cover.
6. Now, you can install the new charger port. Place it into the battery cover and secure it with the two screws you previously removed.
7. Finally, reverse the steps by reconnecting the charger port to the controller and carefully placing the battery cover back into position. Make sure all screws are tightened securely.
It's important to note that you should charge the battery for 12 hours before using the Razor Rambler 16 again.
Please refer to the provided instruction manual for any additional details or safety precautions.
Add New Comment