User Manual Q&AAnswer
Feb 27, 2025 - 06:04 AM
To terminate the Simply45 S45-3600B-W Cat6-6A UTP 180 Degree Keystone Jack, please follow the steps below:
1. Strip off 1.6 inches of the cable jacket. Fold back the drain wire.
2. Insert the cable into the termination cap and fan out all four twisted pairs.
3. Refer to the color-coded wire position printed on the termination cap and position the conductors into the corresponding slots. Ensure that the conductors are in the proper slots.
4. Trim the ends of the conductors.
5. Install the termination cap to the outlet, which will also allocate the conductors sitting on the slots.
6. Secure the hinged outlet by using a crimp tool until it completely snaps to effect the connection.
7. Fasten a cable tie wrap to secure the drain wire on the cable fixture.
Please note that these instructions are a general guide. It is always recommended to refer to the specific product manual or consult a professional if you are unsure about the termination process.
Add New Comment