User Manual Q&AAnswer
Feb 27, 2025 - 05:41 AM
To connect the DAYTONAUDIO LBB-5v2 charger board/module to a power source and batteries, follow these steps:
1. Power Input:
- The charger board/module has three power input options: Solar 19 V (J3), 5-24 VDC (J2), and 5-24 VDC (J4).
- Choose the appropriate power input based on your power source.
- Connect the positive (+) and negative (-) terminals of your power source to the corresponding terminals on the charger board/module.
2. Power Output:
- The charger board/module has five power output terminals, all providing 21 VDC: J15, J24, J22, J25, and J23.
- Connect the positive (+) and negative (-) terminals of your batteries to any of these power output terminals.
- Make sure to observe the correct polarity when connecting the batteries.
3. Charge Current Limiter DIP Switch:
- The charger board/module has a DIP switch to set the charge current limit.
- Refer to the user manual for the specific positions of the DIP switch to adjust the charge current limit according to your battery's requirements.
4. Switch to Change J11 to 12 VDC Output:
- The charger board/module has a switch (not specified in the manual) that can change the J11 output from 21 VDC to 12 VDC.
- If you need a 12 VDC output, enable the switch and connect your device to the J11 power output terminal.
5. LED Indicators and Battery Level Status:
- The charger board/module features LED indicators that display the estimated battery level status.
- Refer to the user manual for the specific LED indications and their corresponding battery levels.
6. External Battery Level Status and Switch Port:
- The charger board/module has an external port (J20) for connecting an external battery level status switch.
- Connect the external battery level status switch to J20 to monitor the battery level externally.
7. External LED Charge and Power Status Ports:
- The charger board/module has two external ports (J1 and J17) for connecting external LED indicators for charge and power status.
- Connect the appropriate LED indicators to J1 and J17 to monitor the charge and power status externally.
Please note that the above instructions are based on the information provided in the user manual. For more detailed and accurate instructions, it is recommended to refer to the official user guide provided by DAYTONAUDIO or contact their customer support for further assistance.
Add New Comment