Answer

Feb 27, 2025 - 04:51 AM
To install the EMTEK EMTouch Classic Style Electronic Deadbolt Lock Sets, follow these steps:
1. Preparation:
- Fasten the Security Plate to the door jamb using two #10 x 3” Wood Screws.
- Fasten the Strike Plate to the door jamb using two #8 x 3/4” Wood Screws.
2. Install Latch:
- Use two #8 x 3/4” Wood Screws to fasten the Latch to the door. Make sure the Latch Assembly is oriented correctly and the bolt is in the retracted position.
3. Remove Screws from Inside Trim Plate:
- Use a Phillips head screwdriver to remove the screws (item #4c) and detach the Inside Trim Plate from the Inside Chassis.
- Remove the Inside Chassis from the Trim Plate before installing the Outside Trim. The Thumbturn must be in the unlocked position.
4. Install Outside Trim Plate Assembly:
- Position the Outside Trim Plate Assembly through the bore hole.
- Once positioned, the Outside Trim Plate Assembly requires support.
5. Install Inside Chassis:
- Confirm the position of the Flat Shaft. The hole for the Flat Shaft must be in the vertical position.
- Feed the Wire Harness through the Inside Chassis.
- Fasten the Inside Chassis using two #8-32 x 1 1/2” Flat Head Machine Screws.
- Connect the Wire Harness and tuck the connectors as shown.
- Install the Battery.
6. Install Inside Trim Plate:
- Fasten the Inside Trim Plate using two #8-32 x 3/8” Flat Head Machine Screws.
- The unlocked position is required for installation and removal of the Inside Trim Plate Assembly.
For more detailed instructions and illustrations, please refer to the EMTEK EMTouch Classic Style Electronic Deadbolt Lock Sets Installation Guide provided with the product.
Add New Comment