How do I install the EMTEK Single-Point Lock Key in xxxx /Lever? (EMTEK Single-Point Installation Guide)

Answer

manuals.plus

Feb 27, 2025 - 04:21 AM


To install the EMTEK Single-Point Lock Key in  xxxx /Lever, please follow the steps outlined in the installation guide provided:



Step 1: Ensure that the small hole on the lock cylinder faces downward. Rotate the key counterclockwise 90º while pressing the wire into the hole.



Step 2: Slide the lever  xxxx  off the stem.



Step 3: After re-pinning the cylinder, insert the lever/ xxxx  onto the stem.



Step 4: Begin the installation process by preparing the lock assembly. Install the strike plate and latch. Fasten the latch using the two #8 x 3/4" wood screws provided.



Step 5: Remove the inside trim plate by loosening the set  xxxx  with the hex wrench provided.



Step 6: Unthread the nut counterclockwise to remove it from the interior plate before installing it on the door.



Step 7: Install the outside trim plate and fasten it using the two #8-32 x 1½" pan head machine screws provided.



Step 8: Install the inside trim plate by screwing in the flat head  xxxx  and threaded nut to secure it to the door.



Step 9: Tighten the set  xxxx  after placing the lever/ xxxx  on the stem.



For more detailed instructions and illustrations, please refer to the EMTEK Single-Point Lock Key in  xxxx /Lever Installation Guide provided by Emtek Products, Inc.



Please note that this answer is based on the information provided in the manual. It is always recommended to consult the specific installation guide for your product to ensure accurate and safe installation.