Answer

Feb 27, 2025 - 03:13 AM
To re-pin the cylinder on the EMTEK Two Point Lock Double Cylinder, please follow these steps:
1. Ensure that the small hole on the cylinder is facing down.
2. Insert the key into the cylinder and rotate it counterclockwise 90 degrees.
3. While keeping the key rotated, press a wire into the hole on the cylinder.
4. Slide the lever/ xxxx off the stem.
5. Once the cylinder is re-pinned, insert the lever/ xxxx back onto the stem.
Please note that this is a general guide, and it is always recommended to refer to the specific instructions provided by the manufacturer for your particular lock model.
Add New Comment