How do I install the ANOLiS HP111 Recessed Ambiane LED Light? (Anolis HP111 Recessed Ambiane LED Light Instruction Manual)

Answer

manuals.plus

Feb 27, 2025 - 02:46 AM

To install the ANOLiS HP111 Recessed Ambiane LED Light, follow these steps:

1. Prepare the ceiling opening: Create a cut-out with a diameter of 133 mm.

2. Disassemble the front frame with optics: Push in and twist the front frame counter-clockwise to release it from the locks. Take out the front frame with optics.

3. Install the control unit: Place the control unit above the ceiling through the opening and mount it to the ceiling using two mounting holes. Use appropriate fasteners for your mounting surface.

4. Connect the primary power: Install terminal blocks on the power cables and connect them to the primary power socket of the control unit.

5. Connect the data cables (DMX or DALI): Install terminal blocks on the DMX or DALI cables and connect them to the control unit. Set the DIP switches to the appropriate positions for your operation mode (DMX or DALI). Set switch 11 to OFF for control by DMX or DALI.

6. Connect the secondary power: Install terminal blocks on the power cables and connect them to the secondary power socket of the control unit.

7. Connect the LED unit: Shorten the cables to the necessary lengths. Strip 41 mm of the LED unit's cable and then strip 6 mm of the individual wires to expose a conductor. Install a terminal block on the LED module's cable and connect it to the control unit according to the wire colors (Red to +A, White to +B, Blue to -, Black to -).

8. Install the luminaire: Make sure all cables are connected before installation. Insert the luminaire into the ceiling opening. Secure the luminaire in the ceiling opening with two holders, adjustable via two screws located inside the luminaire. Use a PH2 screwdriver to xxxx the holders into the extended downward position until they hold the luminaire firmly in the ceiling.

9. Assemble the frame with optics: Position the top frame according to the installation marks, ensuring that the marks of the luminaire and top frame are on top of each other. Insert the top frame with optics into the luminaire. Push the top frame into the luminaire and twist it clockwise until it locks into position.

10. Optional: Install the accessories ring louver for a 20° reflector by inserting it into the top frame.

Please note that these instructions are a summary and it is important to refer to the ANOLiS HP111 Recessed Ambiane LED Light Instruction Manual for detailed information and safety guidelines.