User Manual Q&AAnswer
Feb 27, 2025 - 01:30 AM
To install the EMTEK Sandcast Bronze Rustic Modern Rectangular Pocket Mortise Lock Keyed Function, please follow the steps below:
1. Thread Drive Bar Cylinder: Use the Cylinder Key provided to thread the Drive Bar Cylinder clockwise on the interior side of the door. Make sure the notches on the cylinder are parallel with the horizontal plane when fully screwed into the lock body.
2. Install Lock Body: Insert the lock body into the prepared mortise pocket on the edge of the door. Ensure that the latch bolt faces the direction you want the door to close.
3. Install Outside and Inside Plates: Place the outside and inside plates on their respective sides of the door. Align the xxxx holes and secure them using the provided screws.
4. Tighten Key Cylinder: Use the Cylinder Key to tighten the Key Cylinder from the interior side of the door. Ensure it is securely fastened.
5. Install Trim Plate: Attach the trim plate to the exterior side of the door, aligning the xxxx holes. Secure it with the provided screws.
6. Install Door Jamb: If necessary, install the strike plate on the door jamb, aligning it with the latch bolt. Secure it with the provided screws.
Please note that these instructions are a general guideline. It is always recommended to refer to the specific installation guide provided with the product for detailed and accurate instructions.
Add New Comment