Answer

Feb 27, 2025 - 01:29 AM
To install and connect the elero Revio-868 Built-in Radio Receiver, follow these steps:
1. Ensure that the device is not damaged before installation or commissioning. Only use unmodified original elero parts.
2. All installation work must be carried out by a qualified electrician who has read and understood the operating instructions. Observe any country-specific conditions when installing the device.
3. Use the provided flush-mounted housing with a diameter of 58mm and a depth of 60mm.
4. Connect the stripped wires without end sleeves according to the instructions for the specific type of drive you are using (e.g., tubular motor connection, venetian blind drive connection).
5. Before connecting the drive, check the senses of rotation compared to the device outputs. The first automatic movement in the programming mode must be in the UP/retract direction. If this is not the case, reverse the output connections.
6. Ensure optimal use of the radio signal by not bending, shortening, or extending the antenna. If reception is poor, change the position of the antenna for better reception. Avoid placing the antenna against metal surfaces. Note that using multiple receivers may cause interference.
For more detailed instructions and diagrams, please refer to the elero Revio-868 Built-in Radio Receiver Instruction Manual provided.
Add New Comment