User Manual Q&AAnswer
Feb 27, 2025 - 12:49 AM
To install the Leonton EG2-1600 Industrial Gigabit Ethernet Switch, you can follow these steps:
1. Unpack the switch from the original packing box.
2. Check if the DIN-Rail bracket is screwed on the switch. If not, refer to the DIN-Rail Mounting section in the manual for installation instructions.
3. If you want to wall mount the switch, refer to the Wall Mounting section in the manual for installation instructions.
4. Power on the switch and ensure that the power LED light turns on. Refer to the Wiring the Power Inputs section in the manual for instructions on how to wire the power inputs.
5. Prepare a twisted-pair, straight-through category 5 cable for Ethernet connection.
6. Insert one side of the RJ-45 cable into the switch's Ethernet port and the other side into the networking device's Ethernet port (e.g., switch, PC, or server). The Ethernet port's LED on the switch will turn on when the cable is connected.
7. If you have SFP ports, insert one side of the SFP cable into the switch's SFP port and the other side into the networking device's SFP port (e.g., switch or server). The SFP port's LED on the switch will turn on when the cable is connected.
8. Once all connections are set and the LED lights show normal operation, the installation is complete.
Please note that if you encounter any issues during the installation process, refer to the Troubleshooting section in the manual or contact Leonton Technologies for technical support.
Add New Comment