Answer

Feb 27, 2025 - 12:48 AM
To install the EMTEK Classic Trim Passage and Dummy Pocket Door Mortise Lock, please follow the steps outlined in the installation guide provided by the manufacturer. Here is a step-by-step guide based on the manual:
1. Install Lock Body:
- Begin by preparing the pocket door for installation, ensuring it is clean and free from any obstructions.
- Insert the lock body into the prepared pocket in the door, making sure it is aligned properly.
2. Install Outside Plate:
- Take the outside plate and position it over the lock body, aligning the xxxx holes.
- Secure the outside plate to the door by inserting and tightening the provided screws.
3. Install Inside Plate:
- Place the inside plate on the opposite side of the door, aligning it with the lock body and outside plate.
- Insert and tighten the screws to secure the inside plate to the door.
4. Install Trim Plate:
- Attach the trim plate to the outside plate using the provided screws, ensuring it is aligned properly.
- Tighten the screws to secure the trim plate in place.
For the EMTEK Classic Trim Passage and Dummy Pocket Door Mortise Lock with Modern Trim, the installation process is slightly different. Here are the steps:
1. Install Lock Body:
- Prepare the pocket door and insert the lock body into the pocket, aligning it correctly.
2. Hold Outside Plate in Place:
- Hold the outside plate against the door, aligning it with the lock body.
- While holding the outside plate, mark the xxxx hole locations on the door.
3. Secure both Inside & Outside Plates:
- Remove the outside plate and drill pilot holes at the marked locations.
- Reattach the outside plate and insert and tighten the screws to secure it to the door.
- Repeat the process for the inside plate, ensuring it is aligned with the lock body.
4. Install Trim Plates:
- Attach the trim plates to the outside and inside plates using the provided screws.
- Tighten the screws to secure the trim plates in place.
Please note that these instructions are a general guide based on the information provided in the installation guide. It is always recommended to refer to the specific installation guide provided by the manufacturer for your EMTEK Classic Trim Passage and Dummy Pocket Door Mortise Lock to ensure proper installation.
Add New Comment