User Manual Q&AAnswer
Feb 27, 2025 - 12:44 AM
To remove the panel rear cover of the GENMAX GM6000iED 6000 Watt Dual Fuel Inverter Generator, please follow these steps:
1. Before starting any work, ensure that the generator is turned off and disconnected from any power source.
2. Locate the left exterior cover of the generator. This cover needs to be removed to access the panel rear cover.
3. Using a cross screwdriver, remove the screws that secure the left exterior cover in place. Keep the screws in a safe place for reinstallation later.
4. Once the screws are removed, gently pull the left exterior cover away from the generator to detach it.
5. With the left exterior cover removed, you will now have access to the panel rear cover.
6. Carefully inspect the wiring connections inside the panel box (male plug) and the stepper motor socket (female socket). If any repairs or adjustments are needed, proceed accordingly.
7. When you are ready to reassemble, ensure that the wiring connections are secure and properly aligned.
8. Joint the two sockets (panel box and stepper motor socket) together, making sure to insert the pins correctly. Be cautious not to insert the pins crookedly.
9. Once the wiring is properly connected, reinstall the panel rear cover by aligning it with the generator's body and gently pushing it into place.
10. Finally, reinstall the left exterior cover by aligning it with the generator's body and securing it with the screws that were previously removed.
It is important to refer to the GENMAX GM6000iED 6000 Watt Dual Fuel Inverter Generator Instruction Manual for any specific instructions or safety precautions related to your generator model.
Add New Comment