How do I install the Puig Fender Eliminator Kit on my motorcycle? (Puig Fender Eliminator Kit Instruction Manual)

Answer

manuals.plus

Feb 27, 2025 - 12:39 AM

1. Start by gathering all the necessary components listed in the instruction manual:
- License support (1)
- M6x15 DIN1001 screws (4)
- Plastic bridle (5)
- Back light (1)
- Reflector (1)
- M6 DIN1001 xxxx caps (8)
- M5 DIN1001 xxxx cap (1)

2. Ensure that your motorcycle is in its basic configuration as specified by the manufacturer. The compatibility of the kit with models that have extra factory settings is not guaranteed, so it's important to consult with Puig beforehand.

3. Watch the video tutorial available on Puig's website for a visual guide on the mounting process.

4. Begin the installation by attaching the license support to the designated area on your motorcycle. Refer to the manual for the specific location.

5. Use the M6x15 DIN1001 screws to secure the license support in place. Tighten them appropriately.

6. Attach the plastic bridle to the license support. This will help secure the wiring and cables.

7. Install the back light onto the license support. Ensure it is positioned correctly and securely fastened.

8. Attach the reflector to the designated area on the license support. Make sure it is properly aligned and securely mounted.

9. Use the M6 DIN1001 xxxx caps to cover the exposed M6 screws. Install them on all eight screws.

10. Use the M5 DIN1001 xxxx cap to cover the exposed M5 xxxx . Install it securely.

11. Double-check all the installed components to ensure they are properly mounted and secure.

If you have any further questions or encounter any difficulties during the installation process, you can contact Puig directly for additional support. Their email addresses are info@puig.tv and info@puigusa.com.