How do I install the Linmore LED Troffer Series High Output Troffer? (Linmore LED Troffer Series Output Troffer Instruction Manual)

Answer

manuals.plus

Feb 26, 2025 - 11:59 PM

To install the Linmore LED Troffer Series High Output Troffer, follow these steps:

1. Consult a local licensed electrician or electrical contractor before starting the installation.
2. Review all the warnings provided in the instruction manual.
3. Turn off the electricity at the main circuit breaker, panelboard, fuse box, or disconnect. Do not attempt to install the fixture with the power on.
4. Ensure that the fixture is properly rated for the intended installation location. The fixture is non-IC rated.
5. For grid mount installation, lay the fixture at the desired location in the grid ceiling. Secure the troffer to the structure using seismic wires, safety cable, chain, or hurricane clips. The troffers should be independently secured to the building structure at 2 or 3 points of connection as required by local codes. Make final wiring connections.
6. For surface mount - drywall mounting, assemble the appropriate drywall kit with the screws provided. Support the drywall kit to the building structure by hanger wires or xxxx to wood blocking. Install the fixture into the reserved hole in the drywall kit. Secure suspension cable, chain, or hurricane clips to the structure and attach them to all tabs as required by local codes. Make final wiring connections.
7. Follow the wiring instructions provided in the manual to make final electrical connections. Extend building power wiring to the top of the fixture and feed it through the 3/4" opening on the back of the fixture. Open the driver box cover, remove the knockout for strain relief on building power wires, and make the electrical connections inside the driver box per all applicable codes. Close the cover and tighten the screws.
8. Turn on the electricity at the circuit breaker, panelboard, or fuse box. The fixture should illuminate. If it doesn't, refer to the troubleshooting instructions or contact technical support.

Please note that these are general installation instructions, and it is important to refer to the specific instructions provided in the Linmore LED Troffer Series High Output Troffer instruction manual for your model (part number: HT10S-A1-xxx-xxx-xx-xx-xx-xx-10V).