User Manual Q&AAnswer
Feb 26, 2025 - 11:42 PM
Sure! Here is a step-by-step guide on how to install the EMTEK Square and Round Pocket Mortise Lock for privacy:
1. Start by using the Cylinder Key to thread the Drive Bar Cylinder clockwise on the interior side of the door. Make sure the Drive Bar Socket is in the 12 o'clock position and the notches on the cylinder are parallel with the horizontal plane when fully screwed into the lock body.
2. Next, refer to the template provided for door prep specifications. Follow the template to prepare the door for the installation of the lock body.
3. Once the door is prepped, install the Inside and Outside Plates of the lock.
4. After that, tighten the Key Cylinder by engaging the notches on the cylinder. Use the locking xxxx to securely tighten the cylinder.
5. Finally, install the Trim Plate to complete the installation of the lock.
For door jamb prep specifications, refer to the template provided as well.
Please note that this answer is based on the information provided in the EMTEK Square and Round Pocket Mortise Lock Installation Guide, specifically for the privacy variant. It is always recommended to consult the official installation guide and follow the manufacturer's instructions for the specific product you have purchased.
Add New Comment