User Manual Q&AAnswer
Feb 26, 2025 - 11:37 PM
To install the EMTEK Passage-Dummy Pocket Door Mortise Lock, follow these steps:
1. Install Lock Body:
- Follow the template provided for door prep specifications.
- Make sure the notch on the cylinder is in the 9 o'clock position when fully screwed into the lock body.
2. Install Drive Bar Cylinder:
- Attach the drive bar cylinder to the lock body.
3. Mount Inside Plate:
- Use the template for door prep specifications.
4. Mount Outside Plate:
- Thread the key cylinder clockwise onto the lock body plate.
- Ensure that the key cylinder notch is at the 3 o'clock position when fully screwed into the lock body.
5. Install Trim Plate:
- Attach the trim plate to the lock body.
6. Tighten Locking xxxx :
- Tighten the locking xxxx to engage the notch on the cylinder.
7. Install Door Jamb:
- Drill two 7/64" pilot holes in the door jamb.
- Refer to the template for door jamb prep specifications.
Please note that these instructions are general guidelines. It is always recommended to refer to the specific installation guide provided by EMTEK for your particular model and trim style.
Add New Comment