User Manual Q&AAnswer
Feb 26, 2025 - 11:31 PM
Sure! Here are the step-by-step instructions for installing the Webasto Go Mobile Charger:
1. Choose a location to install the wall hanger. Make sure it is in practical proximity to both the utility receptacle or plug and the location of your vehicle's charge receptacle.
2. Measure up approximately 8 inches / 20 cm from the desired receptacle and mark the location.
3. Drill out the preferred mounting holes through the back of the wall hanger using a 7/32 inch / 5.6 mm drill bit.
4. Using a screwdriver, tighten the screws for the wall hanger.
5. Plug the charger into the wall socket. The blue indicator light should illuminate, indicating that the charger is ready to use.
6. Insert the adapter firmly into the control box. You should hear an audible "click" when the adapter is correctly inserted.
7. Firmly insert the other end of the adapter into the appropriate wall socket.
8. Plug the coupler into your vehicle's charging inlet. For Type 1 coupler, there will be an audible clicking sound when fully inserted. For Type 2 coupler, it will lock in place once fully inserted.
9. The blue indicator light will pulse on and off every two seconds during charging. When charging is complete, the blue indicator light will illuminate solid blue.
10. To disconnect the coupler from the vehicle charge port, press the release button on the coupler (for Type 1) or press the vehicle's Cord Unlock Button (for Type 2), then pull the coupler away from the vehicle.
Remember to follow all safety precautions and consult the user manual for any additional information or troubleshooting tips.
Add New Comment