User Manual Q&AAnswer
Feb 26, 2025 - 11:22 PM
To set the address of the SV-07B injector valve, you can use the valve parameter setting command. The command code for setting the address is 0x00. The parameters for this command are as follows: B3=0xFF, B4=0xEE, B5=0xBB, B6=0xAA, and B7=0xXX. The value range of XX is 00 to 7F. The default address is 00.
To set the address, send the command with the desired address value (XX) to the injector valve using serial communication (RS232/RS485/CAN). Make sure to follow the communication protocol and format described in the instruction manual. After setting the address, the injector valve will respond with a confirmation message.
Add New Comment