User Manual Q&AAnswer
Feb 26, 2025 - 10:51 PM
Sure! Here is a step-by-step guide on how to install the EMTEK Large Multi Point Dummy Function for Door Lock:
1. Align Mounting Plate: Start by aligning the mounting plate with the pre-drilled holes on the door. Make sure the plate is centered and level.
2. Install Mounting Plate: Once aligned, use screws to secure the mounting plate to the door. Make sure the screws are tightened securely, but be careful not to overtighten and damage the door.
3. Install Trim Plates: Next, install the trim plates on both sides of the door. These plates are decorative and cover the mounting plate. Align the trim plates with the mounting plate and use screws to secure them in place. Again, make sure the screws are tightened securely without causing damage.
4. Tighten Set xxxx : Finally, locate the set xxxx on the dummy function handle and tighten it using an appropriate screwdriver or Allen wrench. This will ensure that the handle is securely attached to the mounting plate.
It's important to note that these instructions are a general guide and may vary slightly depending on the specific model of the EMTEK Large Multi Point Dummy Function for Door Lock. For more detailed and model-specific instructions, please refer to the installation manual provided with the product.
Add New Comment