User Manual Q&AAnswer
Feb 26, 2025 - 10:05 PM
To install the EMTEK Back To Back Door Pull, follow these steps:
1. Door Prep: Ensure that the door is properly prepared for installation. This may involve drilling holes or making necessary adjustments to accommodate the door pull.
2. Install Outside Grip: From the inside of the door, align the outside grip with the pre-drilled holes. Insert Bevel Head Machine Screws through the holes and tighten them using a flat-blade screwdriver. Make sure the outside grip is securely attached to the door.
3. Install Inside Grip: Mount the inside grip onto the Bevel Head Machine Screws that are protruding from the outside grip. Align the inside grip with the holes and tighten the set screws (located in two places) using a hex wrench. Ensure that the inside grip is firmly attached to the door.
4. Secure to Door: Once the inside grip is tightened, use the provided hex wrench to secure the door pull to the door. This step will ensure that the door pull is securely fastened and will not come loose during usage.
Please refer to the EMTEK Back To Back Door Pull Installation Guide for more detailed instructions and illustrations.
Add New Comment