How do I install the ANOLIS Ambiane AP LED Lighting? (Anolis Ambiane AP LED Lighting Instruction Manual)

Answer

manuals.plus

Feb 26, 2025 - 10:01 PM

To install the ANOLIS Ambiane AP LED Lighting, follow these steps:

1. Ceiling Opening: Prepare a mounting hole with a diameter between 212-214 mm. If your ceiling opening is bigger, use the Adapter ring (see step 6.B) before connecting power and data.

2. Primary Power Connection: Install terminal blocks on the cable and connect it to the Primary power connection of Ambiane AP's control unit.

3. Data Connection (DMX or DALI): Install terminal blocks on DMX or DALI cables and connect them to the control unit.

4. Secondary Power Connection 48V: Install terminal blocks on the cable and connect it to the control unit.

5. DIP Switch: Unscrew 2 screws on the control unit and remove the plastic cover. Set the DIP switches to positions according to your operation mode. If you want to control the fixture by DMX or DALI, set switch 11 to OFF.

6.A Luminaire Installation: Lift up the springs on both sides, insert the luminaire into the ceiling opening, and release the springs to hold the luminaire in place.

6.B Luminaire Installation with Adapter Ring:
- Slide the Adapter ring under the control unit and above both springs.
- Lift up both springs and slide the Adapter ring under them.
- Install the Adapter ring to the correct position.
- Lift up the springs on both sides, insert the luminaire into the ceiling opening, and release the springs to hold the luminaire in place.

7. Installation of Accessories - Anti-Glare Ring: Insert the Anti-Glare ring into the Ambiane AP until three locks snap into slots. Click on the Anti-Glare ring.

Please note that the installation of the ANOLIS Ambiane AP LED Lighting should be done by a qualified electrician in accordance with all national and local electrical and construction codes and regulations. For further assistance or specific inquiries, you can contact ANOLIS lighting through their provided contact information.