User Manual Q&AAnswer
Feb 26, 2025 - 09:56 PM
To install the kickstand on your Razor W15128785028 Rambler 16, you will need a 6 mm Allen wrench. Follow these steps:
1. Using the 6 mm Allen wrench, loosen and remove the bolt that holds the kickstand onto the frame. This will allow you to remove the existing kickstand.
2. Once the old kickstand is removed, take the new kickstand and align it with the mounting holes on the frame.
3. Insert the bolt through the mounting holes and tighten it using the 6 mm Allen wrench. Make sure the kickstand is securely attached to the frame.
4. Double-check that the kickstand is properly installed and tightened before using the scooter.
Please note that it is important to follow the instructions in the correct order to avoid any potential damage or injury. Remember to turn off the power switch and disconnect the charger before conducting any assembly or maintenance procedures.
If you need further assistance or have any other questions, you can visit the Razor website at www.razor.com or call their toll-free number at 866-467-2967. Their customer support team is available Monday to Friday from 8:00 am to 5:00 pm Pacific Time.
Add New Comment