User Manual Q&AAnswer
Feb 26, 2025 - 09:51 PM
To install the EMTEK S7010 Towel Bar, follow these steps:
1. Locate the Center of Mounting Plates: Make two marks on the wall to locate the center of the mounting plates. The center-to-center spacing for the mounting plates should be the same as the length of the towel bar.
2. Install Mounting Plates: Mark three hole locations for each mounting plate.
3. Install xxxx Anchors: Use a screwdriver to install three xxxx anchors into the wall for each mounting plate. This will provide stability and support for the towel bar.
4. Secure Mounting Plates: Secure the mounting plates using the screws provided. Make sure they are tightly fastened to the wall.
5. Install Trim Plates and Towel Bar: Slip the trim plates and towel bar posts over the mounting plate studs. Ensure they are aligned properly and securely in place.
6. Tighten Set xxxx : Finally, tighten the set xxxx at the base of the post with the Allen wrench provided. This will ensure that the towel bar is firmly attached and will not come loose.
Please refer to the EMTEK S7010 Towel Bar Installation Guide for more detailed instructions and illustrations.
Add New Comment