User Manual Q&AAnswer
Feb 26, 2025 - 09:24 PM
To mount the EATON CWGE-00-01 Water Guard, follow these steps:
1. Ensure that the surface where you plan to mount the Water Guard is clean, dry, and free from dust.
2. Remove the adhesive backing from the sensor cable.
3. Avoid touching the exposed adhesive area.
4. Press the sensor cable firmly onto the desired surface.
5. Once mounted, the adhesive tape cannot be reused.
Please refer to the "How to apply the sensor cable" section in the instruction manual for more detailed instructions and illustrations.
Note: It is important to properly mount the Water Guard to ensure accurate water detection and reliable operation.
Add New Comment