User Manual Q&AAnswer
Feb 26, 2025 - 09:22 PM
To assign a sensor in basic mode for the EATON CJAE-01-01 Shutters-Blinds Actuator, please follow the steps outlined in the instruction manual provided:
1. Ensure that the actuator is powered on and connected to a 230 VAC power supply.
2. Put the sensor in pairing mode by following the instructions specific to your sensor model. Refer to the sensor's instruction manual for details on how to do this.
3. On the actuator, press and hold the "Assign" button for approximately 5 seconds until the LED indicator starts flashing.
4. Within 10 seconds of the LED indicator flashing, press and hold the pairing button on the sensor until the LED indicator on the actuator stops flashing.
5. The actuator and sensor should now be paired successfully. The LED indicator on the actuator should remain solid, indicating a successful pairing.
Please note that the above instructions are a general guideline. For specific instructions and compatibility, refer to the instruction manual provided with your EATON CJAE-01-01 Shutters-Blinds Actuator and the sensor you are using.
Add New Comment